What do people use to suppport lease sticks?

I now have an X frame loom (mighty wolf) and warping is a big pain compared to other large and small looms I've used that have some cross members on which to set and fasten lease sticks.

Where do you fasten and put them in the front for FtB warping and sleying the reed? Where do you put them and support them in the back for beaming on an an X frame loom?

thank you

 

Comments

jordanj (not verified)

I have a Mighty wolf and I hang my lease sticks from a linen thread that I have attached to the high castle. I use shower curtain holders to connect the lease sticks to the linen thread.

Hope this helps,

Jennifer

planttapestry (not verified)

Hmmm,

first there is access denied to the first link. And I had tried a search for "lease" and "all" and never found a previous discussion.

Jennifer, Thanks for the reply and suggestion. I'm unsure of what you mean exactly. Hanging from the castle would put them right up against the heddles which seems an awkward place for them, and then they would be vertical. do you have a picture or can describe how yours work there?

I'm looking to use them near the front beam to sley the reed, and then in the back I want them level with the warp going from the heddles to the back beam as tensioners when winding the warp beam.

debmcclintock

ah, how annoying, apparently you can't go visit a link until you are a member of the group.  Look thru the group list and find the Do It Yourselfer (DIY)group.  Join it, then try the above link. It is a good group to track and learn from.  You even learn things you don't know you don't know!

Don't forget to post a photo, we can help you with specifics on your loom.

tomrsey (not verified)

I was watching Madelyn van der Hoogt's video on "Warping Your Loom - Warp Without Worry"  and she used a similar loom, and showed tying a cord on each side of the loom from the breast beam to the back beam and back.  That is, the cord made a circle, the ends of which were the breast beam and the back beam.    That creates a loop.   Just give a twist when inserting a lease stick through each loop.  I may not have explained that clearly enough.     Great video to see.

Claudia Segal (not verified)

I have a Baby Wolf, x frame loom, and when warping b2f I would use painter's blue tape and tape the lease sticks to the front beam while bringing the warp threads through the reed.  Or, I would sit at a table with the reed sitting upright and the lease sticks behind the reed.  i would rough sley the reed and then put it in the beater.

Another method is to lay long, flat sticks from breast to back beam and clamp the lease sticks to them while sleying the reed at the loom.  Once in the reed, move you lease cross to the other side of the reed (Joanne Hall's book, Warping you Loom does a better job explaining this).  Attach the warp to the back apron rod and beam it on.  

I used to hand the warp from the back beam with shoelaces.  Or try Angel Wings.  Here is a discussion in a Forum (open to everyone, no membership required) where there is a good picture of how to hang lease sticks.  

Claudia

Submitted by Anonymous (not verified) on