I just purchased an 8 harness mighty wolf. I know I will want to do many future projects using an 8 harness loom. Up to this point I have done only 4 harness ( previous on a floor loom but currently only have a table loom).

the problem is: right now I have several projects I want to do on it that are just plain tabby--things I would have done on the 4 harness table loom, but now that I have treadling ability, I want to do plain weave with the new 8 harness loom.

 None of the blooks I have on 8 harness looms even mention how to just do plain weave.

Is this such a stupid question?

 

Do I thread all 8 harnesses?

Do I just thread 4 of them?

Can anyone explain the best way to do this?

 

thank you.

 

 

 

Comments

laurafry

You can thread just two, or four, or spread the threads over all 8 in a straight draw.  Then you just tie up so that you get every other thread alternating.  In other words, if you thread on just two shafts, tie one treadle to shaft 1, the other to shaft 2 and alternate the treadles.

If you thread over four shafts, tie one treadle to shaft 1 and 3, the other to shaft 2 and 4 and alternate treadles.

If you thread over all 8 shafts tie one treadle to all the odd shafts, the other to all the even shafts and alternate treadles.

cheers,

Laura

planttapestry (not verified)

thank you, that is very clear and simple.I knew it should be and I can do that.

Now I'm just wondering if there is a reason to do it one way or the other?

I'm using 1300 ypp chenille at 15-16 epi.

 

Joanne Hall

Hi planttapestry,

Yes, there are things to consider. 

For instance, if you want to make a warp faced plain weave, or even want to put the warp threads a little closer than usual, then don't thread just two shafts, thread at least 4 and more if it is a very close sett.  The sheds will open better if you do that. Also, if you want a tight weave, you will need the weight of extra shafts to keep the shafts down when you tighten the warp. 

But, if you tie up more than six treadles, I would add the treadle holders if you want a tight weave or to keep the tension tight.  They hold the treadles so that the weight of the treadles will not make the shafts go up.  I think that Schacht has information on their website.  I think that they provide rubber bands to hold the treadles up.  Or look at the Leclerc website.  They provide cords with stretchy springs for holding up jack loom treadles when you tie up more than six.

Joanne

Submitted by Anonymous (not verified) on