I purchased a loom with no identification, I cannot find any mark or tag.I it is a early compact counterbalance. I have uploaded pictures to flicker and would appreciate any information you could furnish me as to the origin of this machine.The link to the pictures is http://www.flickr.com/photos/56003433@N03Thank you very much. Jerry Foote

Comments

jerryf (not verified)

I just checked to make sure the link to the pictures worked, the link must be copied into the address bar starting with http thru NO3.

jerryf (not verified)

I dont know enough about this. There are four harnesses or frames that contain the heddles. I'm not sure what is labeled a shaft

Thanks jerry

Joanne Hall

Hi Jerry,

It looks complete.  Go ahead and weave something on it to see what you think.  You may want to add lamms to it (I could not see any), but you can decide that after you weave on it.  And, I think that the beater has been put on backwards.  Try it the other way to see what you think. 

Joanne

Claudia Segal (not verified)

I fixed the link so you can just click on it and it will open in a new window.

Claudia

jerryf (not verified)

I'm searching for lamms and counterbalanced looms and do not understand yet what they do. The treddles are presently hooked to the bottom on the wooden harnesses (the frame with the heddles). Do  the treddles hook to a lamm and the lamms hook to the frames? The beater bar, right now the beater bar has a ledge to the front and none to the back, is this the way you know it is backward?

Thanks Jerry

Joanne Hall

Yes, Jerry,  The lamms are added so that the shafts (you have one harness of four shafts) are pulled down in the center.  Without lamms, the outside treadles will pull the shafts down crooked.  Start with a project using plain weave and just use the center two treadles.  You can add lamms later.

The angle of the reed is also a clue.  So, try putting the beater in the other way.  That ledge is not useful since the sides of the beater would obstruct the movement of your hand if you tried to use it to support the shuttle.  And, counterbalance looms do not need a shuttle race.

So, make a warp and put it on.  You will know more about your loom that way.  If you don't know how to put the warp on, contact me at [email protected] for more resources.

Joanne

amyfrey (not verified)

I also recently bought a counterbalance loom that doesn't have wooden lamms.  Instead it has a chain suspended parallel to the bottom of each harness.  You then connect the cords to the treadles and the chain with S-hooks.  After a couple of dozen trips to the top of the loom then back to the floor, I finally have the length of cord and the position of the hooks pretty well sorted out.  I'm just using shoelaces at the moment until I can get some proper cord.  It's working well, makes a nice shed, and I'm working on a small sample warp with twill and tabby weave.  I hope to get a warp on and make some scarves for Christmas presents.

Amy

Tona

I have this same loom, though I think mine might be maple instead of oak. It's al really light color.  Did you ever find out the make and model?

Tona

Submitted by Anonymous (not verified) on