I am planning a warp that the pattern repeat is 21 ends. Its M and W the M would be one color and the W another. I have alway warped with even numbers in my colors. Any ideas of a easy way to do this. I plan to do it so the thread repeat is my epi. So it would be 21 epi.Thanks

Comments

Bonnie Inouye (not verified)

Why does it matter if the threads in one repeat happen to be an odd number? I doubt that you are going to thread just one repeat. Look at the total number of threads you will need for your piece, in each color, and wind the right number of threads overall.

When choosing a sett, that depends on the size of the yarn and the intended weave structure (actually, the number of interlacements, which is related to float length) and the desired effect. I look at those factors and then see which of my reeds will be most suitable. I never consider the repeat size as having anything to do with sett, so I am curious to learn why you want them to match? Is it because you must have a one inch repeat for this project?

I prefer to sley 2 threads per dent. You have an odd number in a repeat because it is a symmetrical threading and you don't want a double thread where the first and last would be the same. However, you will add an extra thread to the end of the warp. What size is your warp yarn?

Bonnie Inouye (not verified)

Consider changing the threading so it has a number of threads that pleases you.

lkautio (not verified)

Laurie, is the reason you have warped with even numbers so that you start and end colors only from one end of the warping board or reel?  It is fine to start and end on both end  pegs, just try to keep the knots on the front peg as close to the peg as possible for least waste.

Laurie Autio

Lauries (not verified)

Yes that is why. I am worried about more  waste. I have enough as it is. Also when I put it in the raddle, if one thread is in one space and one in the next,  will the ends tangle as I wind the warp?

lkautio (not verified)

If you are careful to make your knots close to the end pegs, you will have little to no more waste.  The ends should not tangle in the raddle.  I never worry about which end the knots fall on and have no trouble with it.

Laurie Autio

lkautio (not verified)

Warp back to front and don't cut the ends.  Slip them over a dowel and tie the dowel to the back apron rod.

Lash on at the front (see Ostercamp for good directions). 

If you cut off between projects consider waiting instead or weaving in a stick, glueing it, and lashing on to the stick (very little waste or time involved).

Depending on the loom you may be able to weave until the apron rod almost touches the back shaft.  With some looms it requires some finagling with the shed (a sword will help with the last few).

Plan your fringe (if your project has one) to come out of the waste in front and back.

Laurie Autio

Lauries (not verified)

The project will be towels so I usually put waste yarn between. Thanks for all the ideas. I plan to do this more than once so after afew I will get better at it. I like point twills and they also sometimes are uneven threads, so I need to bite the bullet and just do it.  

Submitted by Anonymous (not verified) on