Counterbalance looms in the US are usually only four shafts, but more can be added in a number of ways.  If you want more information, contact me at [email protected]. 

You might only need a couple drall pulleys, or another sett of horses and plain pulleys.  Of course, you will also need more treadles, lamms and heddle bars.  For small looms, all these parts should be thin and you may need to make thinner parts for your original four shafts, lamms and treadles.  The Big Book of Weaving has some instructions for tie-ups.  Contact us for more information.

Joanne

Comments

Claudia Segal (not verified)

I keep trying and my shafts are still crooked.  I put the shaft holders on, measured each texsolv cord, tied everything up matching and took off the holders and shafts 1 & 2 are crooked.  I have a narrow warp on, could that be the problem?

Here are a couple photos:

Any assistance greatly appreciated.

Claudia

Joanne Hall

Hi Claudia,

Yes, a narrow warp requires extra ties.  You can use the elastics on the ends of the shafts, just like one uses on a drawloom.  Or, on page 242 of The Big Book of Weaving is another solution.  I have a page in my new book, Learning to Warp your Loom that gives these extra tie-ups.

Remember, you only evaluate your tie-up when you are pressing on a treadle.  Where the shafts go when you are not weaving is not important.  When you are not pressing on a treadle, the shafts move based on the weight of the treadles on the lamms, since they are very lightweight.  With a wide warp, they stay in place. 

Joanne

Submitted by Joanne Hall on