Yes you can! I often weave 3 selvedge pieces by passing a steel needle through my end loops and then lashing that to my loom bar. Like so........
This is a fine knitting pin sold in sets of 4 for circular weaving. A cut down coat hanger would work too. I use cut down piano wire for wider warps. When you finish weaving you remove the needle and then pass the weft tail through the loops with a sewing needle.
For a 4 selvedge piece you would do the same at both ends of the piece. The weaving would proceed like this..........

A- warp as it comes off the warping board.
B- warp ends around needles and lashed to loom bars.
C- weaving up to half way
D- turning the weaving around to start weaving from the other end.
E- removing the shed stick and placing it on the far side of the string heddles.
F- weaving until you can't go any further. First using thinner and thinner shed sticks, then removing the shed stick and using only the heddles for one shed and needle weaving the other. Eventually removing the heddles and needle weaving in the last rows.
This is tough with a warp faced weave where the weft is beaten in hard but quite manageable on a balanced weave.
Franco has made dish towels like this.
Some photos of my weaving teacher closing my piece with a needle.......
The closure will be in plain weave-there is no way you can continue the pick up patterns all the way to the end. I did a supplementray warp piece where I was able to go almost to the very end. The thick row holds the final weft passes.
Laverne Waddington
Comments