Yes you can! I often weave 3 selvedge pieces by passing a steel needle through my end loops and then lashing that to my loom bar. Like so........

This is a fine knitting pin sold in sets of 4 for circular weaving. A cut down coat hanger would work too. I use cut down piano wire for wider warps. When you finish weaving you remove the needle and then pass the weft tail through the loops with a sewing needle.

For a 4 selvedge piece you would do the same at both ends of the piece. The weaving would proceed like this..........

A- warp as it comes off the warping board.

B- warp ends around needles and lashed to loom bars.

C- weaving up to half way

D- turning the weaving around to start weaving from the other end.

E- removing the shed stick and placing it on the far side of the string heddles.

F- weaving until you can't go any further. First using thinner and thinner shed sticks, then removing the shed stick and using only the heddles for one shed and needle weaving the other. Eventually removing the heddles and needle weaving in the last rows.

This is tough with a warp faced weave where the weft is beaten in hard but quite manageable on a balanced weave.

Franco has made dish towels like this.

Some photos of my weaving teacher closing my piece with a needle.......

The closure will be in plain weave-there is no way you can continue the pick up patterns all the way to the end. I did a supplementray warp piece where I was able to go almost to the very end. The thick row holds the final weft passes.

Laverne Waddington

 

Comments

cookie48 (not verified)

What size and length steel knitting needle you used, Laverne.  I can locate steel knitting needles earlier than I can piano wire.  Where can you find piano wire?

Cookie48

Caroline (not verified)

Cookie, you should be able to get piano wire from somewhere that sells musical instruments, though perhaps you would need to order it in. If you know a friendly piano tuner, you would have a never ending supply, ;-) !

Otherwise look in your LYS for a set of lace knitting needles - they are steel and very tough compared to regular knitting needles. They also have sharp points on them, and are very fine, sort of like a slightly thicker darning needle

hope this helps,

Caroline

bolivian warmi

Just use the steel knitting needles Cookie. I only bought the piano wire as it comes in super long lengths and I can use it to do really wide pieces. My brother got it from some kind of local engineering store when I was in Sydney but I have googled it and it seems that it is easy to get hold of. Anyway, I am sure the knitting needles will do for now.

rose Goldielocks (not verified)

I find "piano" wire at a hobby shop that sells model airplains and radio-controled stuff (dune buggies, boats, planes). Generally it is near the display of copper/brass and steel tubes.

Submitted by bolivian warmi on