Hi All - I'm new here and a new weaver. I am using a Schacht Flip RH loom. I warped successfully and am now on to weaving. I've woven about 4-6 inches of cloth so far. However, as I've advanced the warp, it has gotten tighter and tighter to the point where I cannot turn the handle successfully. I also cannot seem to loosen the back part of the warp either. 

Does anyone have any tips around advancing the warp? The last time I advanced it the heddle jumped out of place - so I'm thinking that there really must be too must tension. However, I'm a newbie, so who knows?

Thanks!

Comments

ingamarie

Hmmm I don't weave on a Flip so maybe there's something else going on... but here is how I advance the warp both on my RH Emlia and on the big floor loom-- I loosen the front a notch or two first, then loosen the back, then wind on the front and tension it again. 

Can you get the pawl (peg) off the ratchet on the front beam?  Once you have the tension off the warp, then you should be able to  loosen the back enough enough to wind off some warp.

  I wouldn't worry about the heddle jumping around--it's held by the threads at this point just deal with winding the warp forward then put the heddle back where it's supposed to go. How much tension you put on the threads depends on what you're weaving and what fiber your using, On a wooly knitting type yarn, I'll tend to use a bouncy tension. Enough to keep things under control but not so much as to stress the warp. With linen I crank it up quite a bit.

Hope that helps!

marie

claudia (not verified)

Hi,

Along with the suggestions above, it's also possible that one thread is caught in a heddle hole/slot and won't advance.  Sometimes that happens, especially if you are working with a heavier yarn, like a worsted weight.  Check to see all the threads are moving through the heddle properly. 

Can you take some pictures and post them?  Take a shot of the front and back beam and the heddle and we may be able to diagnose your problem more easily.  Get as close as you can and post them here.  If you need help with how to post pictures, it's available here in the Help section.

Claudia

maureenbr (not verified)

 Thank you both for your help. I checked the threads and found that they were okay. When I loosened the front beam, I am able to loosen the back, and then advance the warp successfully. I think I may have been so concerned about tension that I made it all too tight, so I will be keeping my eye on that. First project, so bound to make some mistakes!

Again, thanks very much for your assistance.

ingamarie

Good to be philosophical in the beginning.  To paraphrase Laura Fry-- 'your first project is to make a weaver'

Submitted by Anonymous (not verified) on