I need some advice...I'm changing the heddles on my little CV11 Macomber.   Right now it has flat ordinary heddles (many of which are bent)  Im changing to inserted eye heddles that I just got from Halcyon.  I only ordered 400...I have a 8 shaft loom so can i change out 4 shafts and leave the old ones on the back 4 shafts?  or should I order some more and have all 8 shafts with the same kind of heddles?   Also, is there a good way to store the old ones?  I think I read a storage hint somewhere, years ago, and I don't remember what the hint was.   thanks for your help!   --Rebecca

Comments

weaver-dyer (not verified)

I left the flat steel heddles on the back four shafts of my Baby Mac for a number of years after I switched to the inserted eye heddles on the front four shafts.  If you plan to use the rear shafts along with the front four shafts, you need to make sure that the eyes of the heddles are at the same height. 

Before removing the old heddles, slip both heddle bars out of the shaft frame.  Only need to do this on one side--be careful not to drop them.  Tie a long sturdy string through the hole in the top heddle bar and also through the hole in the bottom heddle bar.  A long shoe lace works well.  Slide the heddles off the heddle bars and onto the string or shoelace. Tie the ends of the string or shoelace together.  The heddles are in order and can easily be put back on the loom if needed.

 

 

 

lkautio (not verified)

A pipe cleaner also works well, as do large safety pins.  Don't remove them until you have them on the new heddle bar and the heddle bar secured again.  You shouldn't have trouble with the two heddle types as long as you keep them the same on each shaft.

Laurie Autio

Michael White

Hi, Cheryl has three Macs, on two of them the heddles are all mixed up. Two types of flat, some wire and a few repair heddles. Someday she will change them all out for flat heddles. As long as the heddles you have are the right size it mades no differences what type they are. If they are not giving any trouble, go for it. Remove the old one from the front and then if you need them put the good ones on the back. When you remove the old heddles run a string thought all of them, top and bottom, cut out the bad ones and spray the heddles with a light oil and then wrap them in brown paper and store them in a "DRY" location.

Michael

TinaHilton (not verified)

I added inserted eye heddles to my used Baby Mac because there weren't enough.  I put the new heddles in the middle (where I'll use them for scarves, which is what I mostly weave on it) with the flat steel heddles on the edges for when I weave something wider.  I did get rid of all the bent and rusted ones when I did this.

Submitted by Zone5gal on