I just finished my 2nd project - see below and I have a question on the selvedge endings.  When I run out of bobbin thread I am running it back through for about an inch and someone said that I can just cut it off at the selvedge to make the weaving more even.  But wouldn't it potentially pull back and not as secure?

Comments

sally orgren

Good question! I always weave back in about 1" of the tail before a color change so it won't come undone. (Yes, there ARE ways to make this less noticeable.)

But here is why it "depends." If you have a fairly loose weave structure, or want a finished edge for an item like a scarf or a runner, I would recommend weaving the tails back in. If you are planning to cut this up and use it for garment fabric, no worries. Don't bother.

In lectures by Marjie Thompson about historic weavers, you will hear that they did not worry about these weft ends. The difference is they were weaving at a much higher epi than we typically do today, and they were often using linen, which doesn't shrink much. The ends were left to just "wear away."

If you don't want to weave the tails back in, I would suggest leaving a long tail and finishing (washing) the fabric before trimming them off to the selvedge. You need to allow for take-up (the amount lost in width when the fabric is removed from the tension of the loom) and then shrinkage, (a second loss in width when the fabric is wet finished). If you trim while on the loom, under tension, you could end up with weft ends shorter than the width of the piece when you remove the piece from the loom and wash it.

If you are weaving at 30 epi or higher, you might be able to get away with finishing and then trimming the weft ends even. But lower than that, and working with a stretchy fiber like wool, I wouldn't risk it.

sequel (not verified)

It's the overlap that secures the weft end.  I turn in the end of the last weft pick, 1/2 to 3/4", into the next shed.  Then I weave with the new bobbin leaving a tail at the overlap edge that I can trim off.  This makes a small overlap that secures the weft and is as unobtrusive as possible.  The wider the sett, the longer the overlap needs to be, but this can also bring too much attention to itself.  So I would taper the overlap near, but not at, the selvedge.

Changing colors is a a whole 'nother chapter...

anxious1

Thank you everyone and I think what I am doing is working and seems to be securing well.  I guess I will  have to cross the color change bridge when I get there. 

Submitted by anxious1 on