This was a thread in Yahoo Weaving that attracted a lot of attention, so I thought I would post it here.
. I get mill end rolls of cotton fabric from Great Northern Weaving in Kalamazoo MI. These are rolls of fabric on a cardboard tube that have been cut off a larger roll. They mail order the smaller rolls, but the really big ones (30-50#) they don't. The way the cutter works is that the roll is held below the cutting deck with a 2" dowel as an axle. The cloth is pulled up the back of the cutter, over the rear roller and pulled forward over the cutting deck (piece of plywood). A 2x4 with ~12 razor knife blades set into it is pushed down through the cloth into a piece of styrofoam insulation board and clamped in place on the cutting deck. I grab the cloth end and walk backward, The razor knife blades cut the cloth into strips as I walk backward.




