I'm sure I'll be embarrassed to find out how simple the solution to my problem is, but here goes. I just bought a used Mighty Wolf and am ready to put on my warp. I want to pull the beater forward and lock it in place so that I can sley the reed, but I can't figure out how to pull the angled beater pin through the loom leg, out of the way, so that I can pull the beater forward and reinsert the pin to lock the beater in place. Pulling an angled pin through a small hole drilled through a piece of wood seems impossible, but there is even a little place to hang the pin on the other side, so it must be able to come through there somehow. Any tips? Thanks so much!

Comments

Barbara Keyser (not verified)

Hello - I have a Mighty Wolf that I bought last year, the Beater Pin is attached to the outside of the Loom crossbeam, attached to the pin holder with a chain so it doesn't get lost.  If yours is on the wrong side, try detaching it from inside the loom & re-attach to the outside of the loom so you can hold the beater while warping.  If that doesn't seem workable - post a picture, maybe the setup is different on an older loom. 

woolgirl (not verified)

Do you have a copy of the MW instruction manual - it discusses the beater pin? You can find it on the Schacht website here. You can also zoom in on the photo of the MW - it shows the location of the pin on the outside of the right front leg.

HTH! ;)

Submitted by AwesomeCactus on