Greetings,

I'm attempting to wind on a 14 yard Schact warping board a warp that is 10 epi and 20" wide.  Ergo, 200 warp threads.  I'm only halfway there and am almost at the pegs.  Any solutions out there.  I really don't have room for a warping mill and am hoping other folks have already found their way around this.

 

cheers,

April

Comments

Dawn McCarthy

Are you pushing the threads back on the pegs?  The threads do not need to lay exactly next to one another on the pegs - spacing and sequence are maintained by the cross.  If your warp is a heavy yarn or a very wide warp, you can split the warp in two.  For example if your warp was 20 epi at 40 inches you would have 800 ends, if this did not fit on the pegs you can make 2 warp chains each of 400 ends, be sure to follow the same warping sequence and ties etc.

Dawn

http://bloominloom.wordpress.com

 

endorph

did a similar warp on my Schacht warping frame - I split the warp into two bouts and had no trouble - It was also easier to keep the lemgth of each round even which made getting a nice even warp on the loom - ie. beeaming on was much easier with the two bouts. I have also done a warp with 300 ends at 10epi and split it into three bouts, that way there was no crowding on the pegs on the warping frame.

argyarn (not verified)

Hello, Thanks for the speedy responses and good to know.  I did start to push them back and with much lipbiting I did get all 200 threads on there.  I know next time that it's ok to them in batches.  super helpful!

 

cheers,

April

laurafry

I only wind up to a maximum of 15" worth of warp in a single chain.  For a 20" wide warp I would do as Dawn and Endorph - split it into two.  You may find my You Tube video on winding warps helpful:

http://tinyurl.com/d2m3xlh

cheers,

Laura

argyarn (not verified)

I loved your article on efficient weaving in the last WSD Journal.  Thanks for responding to my post, and I'll follow everyone's good advice.

 

 

laurafry

arrived yesterday - haven't had a chance to read it yet.  :)

cheers,

Laura

Submitted by Anonymous (not verified) on