I am a very new weaver and have just taken my first project (a handspun scarf) off my jack loom. I am now setting up my warp for a dishtowel project and typical of me, am thinking of alternative ways to do things.
I learned to dress front to back, cutting both ends of my warp bundle...the front gets tied to the breast beam while threading the reed and heddles, then the back gets tied and wound onto the warp beam, then the front ends get tied to the fabric beam.
What my idea is: instead of cutting both ends of my warp, cut the end that will be going through the reed and heddles but on the other end, simply slip a sturdy rod through that end, tie the rod on to the rod on my fabric beam, wind the excess warp on to the fabric beam, thread the reed & heddles, tie to the warp beam and proceed as usual. In other words, there would be no knots (and less waste) on the fabric beam. I think I might have to make 2 crosses, one at either end of my warping board) to keep the warp in order, or is that necessary?
Is this feasible? What do you think? :^)
Comments