I have been weaving on a Harrisville plain back beam for over a year and have no problem. At Christmas, I got a Union loom 36 and the equipment for sectional warping, but I just cant do it. The threads tangle and break, always on the right side, and I absolutely hate it and am ready to chop off the wooden separator spikes. Is there a good book with pictures and thorough explanation? thanks

Comments

Lauries (not verified)

I think the book Rag Rug Handbook by Paula Pfaff and Janet Meany has information in the back for sectional warping. Also on Weaving Today there is a new e-book on warping. I am not sure it has sectional in it but its worth a look.

Karen S

I'm assuming you are using multiple thread spools.  Are you using the thread guide that came with the Union loom or are you using a tension box and a spool rack?  I had problems warping the Union when I tried putting the spools on the pegs on the loom and using the thread guide.  I love sectional warping and even bought a sectional beam for my Harrisville loom.

You can get a copy of the instruction manual for the Union 36 from the following:

http://www.weaversfriend.com/page1/page1.html

Joanne Hall

Some of the older rug looms use the wooden sectional pegs for the braking system.  So, check your loom before you cut them off.  And if you look at the Leclerc website, you will see the equipment they have for sectional warping.  You can compare that to what you have.  Maybe you need something that you don't have to be successful with sectional warping.

You can warp the loom as you have been, but you just need to be sure that the warp doesn't get caught on the pegs as you wind it on.  And if your warps are 10 yards or less, you might just want to keep warping as you have been, until you want to make much longer warps.

Joanne

FiberFever (not verified)

yes, my union loom uses the pegs for the braking system, I have not cut them off yet, but was going to leave the ones on the ends for the brake and cut off the middle ones in order to warp, but i have the spool rack and tension box. Isn't that all i need? Is there ever a problem where the reed itself cuts the warp? I notice that each time this happens it is always about the same place, but also, the warp gets hung on the beam spikes at about that same place, so not sure which place is the culprit. I thank you for your help. will hold off with the saw for now....

Karen S

Okay, I think your question about the reed may have given me a clue.  Do you mean that the threads are breaking as you warp, or as you weave?  If it's happening when you weave, it sounds like uneven tension.  The shorter threads are breaking.  Even with sectional warping, the same principals apply.  The tension must be even across the entire warp.  If you are having high and low places in your sections, you will have short threads and long threads.  It can also happen if a few threads in the end section "migrate" over to an unwarped section.  Doesn't look like a big problem until you try to weave it off.  Voice of experience here.  I've fought many uneven warps through the years.  

My advice is to stick to shorter warps until you get the hang of it.  If you wind on 30 or 40 yards and end up with popping threads, you'll end up throwing that old Union through a wall.

Submitted by Anonymous (not verified) on