Most often, I use a HW magazine project, and follow directions carefully (my best talent). I decided to branch out on my own and completed a plaid wool scarf without a published pattern; I used the following knitting yarns (those are strips of t-shirts for fringe spacers) on my 8H Schacht Mighty Wolf:
dark blue tweed - Tahki Yarns - Tara Tweed (80% wool; 20% nylon) - 1115ypp
light blue - Brown Sheep Company - Lanaloft Sports Weight (100% wool; "mothproofed") - 1326ypp
The scarf is a simple tabby, sett at 10epi with approximately 10ppi. On loom, the scarf (under tension) measured 80.5" and it was 9.0" in the reed. Off loom, it measures 76.5" (5% dimensional loss) and 8.2" (8.9% dimensional loss). I do have 3 inches of a "sample" at the beginning of the project. Sample and scarf were both hemstitched at each end. I plan to ply the fringe (before wet finishing) - 4 ends (2x2) per bundle, and I did use 4 ends per hemstitched group. At the moment, I'm not sure how long the fringe should be after wet finishing
Now, I'm very nervous about wet finishing. I do have a new top-loader (Whirlpool Cabrio), but I can control water height and spin (since water is softened, I will use HE detergent). I would be very grateful for advice/suggestions on the wet finishing process for this scarf, as I am rather nervous about how it will finish (there is about an 1/8th inch more draw-in where I used the dark tweed in sections of the weft). MANY thanks in advance.
Pat
Comments