I am trying to work through the lessons in Nancy Arthur Hoskins'  Weft Faced pattern Weaves, and I am unable to get anything weft faced with her recommended sett of 10 dpi. Is there a way to estimate sett for weft-faced as there is for tabby and twill?

Nancy

Comments

mneligh

Look at the book Warp, Weft, Sett.  It's a function of all 3.

tommye scanlin

In tapestry, which is weft faced, Archie Brennan recommends to wrap a possible warp yarn closely around a centimeter measure, then use that # as the warp ends per inch. Warp tension also needs to be tight for weft faced. And weft needs to be arced or bubbled well. Hoskins uses cotton weft for her book, I think. The book is at my studio so can't check it right now.

ReedGuy

I've done crepe with wool singles and double ply with the warp totally hidden on both sides when wet finished. Sett of 16 and 8 epi respectively.

Warp in this sample sleeve of wool 2-ply is green and yellow. 8 epi

 

tommye scanlin

I'm looking at the Hoskins book, pg. 26. The recommended warp is either 12/6 cotton seine twine or Bockens rug warp, with substitutions noted as either 5/2 or 10/2 pearl cotton, or 8/4 carpet warp. You didn't mention what your warp is... any of those she's listed, sett at 10 epi, should allow for the weft to cover... if... the tension is tight enough and if the weft is appropriate in size. Her suggestions of 5/2 pearl cotton or the wools she's mentioned should work out to give you weft coverage. And... since the samplers are narrow in width, she recommends placing the weft at an angle, closing the shed and then beating (rather than the arcing or bubbling I mentioned in the other reply). I hope it will work out for you successfully. I worked through several of her chapters a few years back and found her information about how to read and then to design for weft-faced pattern effects to be very enlightening. Hope to see your results in the project pages soon! Tommye

phiber phanatic

Thanks, mneligh. I ordered the book.

Tommye, I was using 8/4 rug warp and 3/2 pearl cotton at 10 dpi. I rethreaded at 5 dpi, and everything worked like a charm. I don't know how flimsy the fabric will be, but my next warp will be at 8 dpi.

Submitted by phiber phanatic on