Im almost finished planning out a shawl pattern. Whats left is to figure out what to do for the header and the footer...

Im using a crackle design from handweaving.net (draft#13894) - I have so far only used twills and tabby so this will be a nice change ;)  - But I'm not sure how to go about the header for this. In the past I've used plain weave. The threading for this crackle design is not as forgiving ...

 

Any Ideas? Or should I just not worry much about a header and make sure my finishing of the project is perfect?

 

Thanks ;)

Comments

laurafry

Not exactly sure what you mean by a header and footer in this context.

I always weave a 'header' at the beginning to make sure everything is working as it should, testing my choices of weft yarns, checking for threading errors.  Then for a shawl or scarf I advance the warp about 6" for a 3" twisted fringe or an inch or so if I'm hemstitching. 

If fringe twisting I weave 4 or 6 picks of waste yarn, then begin the scarf/shawl.  For crackle or other weave structure that has a tabby pick I might weave two picks of tabby before beginning the pattern.

At the other end I would finish the way I started, weave 2 to 4 picks of waste yarn, advance 6" and weave 4 to 6 picks to act as a keeper of the warp ends until the fringe twisting was done.

For hemstitching I would weave 3 picks of tabby and then hemstitch, throw a fourth pick and then begin the pattern.  The other end would be treated the same way.

Hope this makes sense - if not I'll try to clarify.

Cheers,

Laura

 

Elisabeth (not verified)

This does make sense - I'm just not sure how to do the tabby due to the threading order of the pattern... I'm not sure how to describe it, but its a long repeat and every other thread is not necessarily available in a separate shaft. That's where I am a bit lost.

 

I would like to hemstitch this the more I think about it, but I want to make sure that the weave structure is more secure than the crackle pattern. Its a 5 shaft pattern that repeats every 76 threads or so. For the salvage I was planning on using 2 separate shafts to weave tabby - I couldn't think of any other way to thread it since the tie up and treadling follows the threading pattern.

(Header and footer was the term used in Deborah Chandler's book Learning to Weave)

Thanks for the help!

Elisa

laurafry

Not all weave structures will produce a true plain weave.  In that case just do the best you can - if you can't be perfect, be consistent.  :)

cheers,

Laura

Submitted by Anonymous (not verified) on