was wondering whats the longest warp the dorothy leclerc can take? I am going to warp using a 2/18 merino and the length of the warp is going to be 7 1/2 yards Do you think it will hold it?

Comments

Margery (not verified)

 

Oops - just got back to the forum - I forgot the Dorothy was a table loom - so as everyone else said - 7 yards or less........

 

Changed my previous response.

Michael White

Unless someone know the answer, I would put on a piece of cotton about the same weight and just turn one piece on the beam to see how much it will hold. You would them measure the dia of the beam times the number of turns to get a ballpark length. Or you could measure the thread.

Michael

Elk Ridge Orch… (not verified)

thanks for idea

sally orgren

I have lots of table looms, but no longer own a Dorothy. I use Voyagers, made by the same company, and they are somewhat similar in their limitations for long warps.

I am pretty certain I have warped 7 yards on my table loom @ 5/2 or 10/2 cotton at least once. I usually limit my table loom warps to about 5 yards. Yes, you might be able to get 7.5 yards on the back beam at that size, but realize you likely wouldn't be able to weave it all off in one piece onto the front beam. 

The limitation is the space between the cloth or warp beam and the breast or back beam on the LeClerc table looms. 

Keep in mind, you usually pack the first complete rotation of the beam with sticks, or something that smoothes the surface from the underlying rods, cords, and/or knots, so that first rotation builds up quickly. (I also use paper towel tubes that have been slit, so they pop on easily to cover the irregularities at the beginning of a warp.)

After the first complete rotation to cover the knots, you probably use craft paper, which is incidental in terms of adding depth. On my table looms, I usually use another stick layer half way through a longish warp. Because the beams on a table loom are very small in circumference, the paper may not be enough to keep the ends on a very long warp from creeping toward the edges, which may change their length, resulting in tension issues when weaving. A solid layer of sticks at the midway point of beaming (or even at 2 different points) a 7+ yard warp reinforces those ends and keeps the selvedges equal to the tension in the middle of the warp. 

If you try Michael's experiment, be sure to account for your packing method. And consider how long each finished piece will be, and will it fit on the front beam, when the weft has been added and it is 2x as thick?

Good luck, and let us know where the project goes—

Elk Ridge Orch… (not verified)

so as for the front I am making three scarfs out of same warp so i can cut off as I make them that will make the front beam better thanks for suggestions.....

Michael White

to helm stich each scarf on the loom before cutting. Also remember to add addisional lenght for tieing on each scarf.

Michael

Elk Ridge Orch… (not verified)

purchased a kit from someone for a set of tartan scarfs that i am doing for a friend for fathers day gifts I will pull off each scarf when completed plus I can do a sample for myself will post pictures just did warping board tontie = hope to put on loom this weekend

Elk Ridge Orch… (not verified)

just finished warping on back beam with room to spare! WOOHOO now just need to thread the heddles and then the reed! will post pictures on my project page

jenjscott

I saw some kits like that and wondered how they would work out.  Be sure to let us know.

Submitted by Anonymous (not verified) on