I see that some looms out there are made from unfinished wood.  Curious to know if people usually treat them themselves after purchasing?  Why or why not and what have people tried that worked well?

Comments

Erica

I haven't done anything with my Glimakra, but I've only had it a few years. As far as I know in my climate it's OK to leave it untreated.

I look forward to reading what others have to say on this!

karentiede

I came into a 1959 Newcomb Studio that the previous caretaker had stripped.  I hate naked wood, so I finished it with tung oil.  I think the original finish was shellac.  My house runs a very wide humidity range and I like to think a finish helps keep the loom from moving as much as it might otherwise.

ReedGuy

Finished wood will move just the same actually, might be a slight difference in time. I finish wood because it protects it from fungus and mold over many years. Of course it's not going to deteriate like out in the woods, that's common sense. Certain parts I have learned should not be finished, like the shafts as they can become too slick. Rollers and roller shafts should be treated with linseed/turpentine or a finishing oil. Then wax the roller shafts because of friction on the wood. I would also use the oil on the lamms and jacks (countermarche) and wax all metal holding rods (jacks, rollers,treadles,lamms).

steve104c (not verified)

ryashani,  I have a Glimakra. When I got it I had  to strip it, sand and then refinish it. I used shellac. Really easy to apply (you can use a rag) and dries fast. I suggest that you put something on it.  Don't want the wood to dry out." Will warp". Don't need to stain, but you do need to put something on to seal it from moisture..........Steve.  Woodworker(Professional) for 26+ years.

Sara von Tresckow

Most Scandinavian loojms ARE finished. The Oxaback line is finished with thinner/linseed which gives the appearance of unfinished wood, but is sealed. Finnish looms are generally lacquered, and Glimakra looms also have a finish on them.

If you get one used and it is bare wood, then something simple like the thinner/linseed will seal the wood against stains, etc.

Shaft bars and lams are not finished. Treadles can be either way.

ReedGuy

Note that the holding rods I refer to are the threaded steel rod that holds those parts on.

ryashani (not verified)

Thanks for the advice and thank you Sara for saving me from emailing you.  I am looking at used looms but my dream-loom is the Lilla and I was going to send you a message asking if it was treated or not and if it wasnt, then what you recommended doing to treat it.

Submitted by Anonymous (not verified) on