Hello All,

I have a question.  I think that this may be something used to repair a broken warp thread but I am not sure.  Does anyone know?  Thanks everyone.

Comments

sequel (not verified)

It is likely a spool to hold the extra warp for repair or addition of a warp end.  I've read about these, but never seen a commercial product.  The metal device may be to mount the thing somewhere, between two pieces probably on the base of the loom. 

OR

It is for that spool that you see hung from the castle of looms in antique pictures.  Never knew what they were for either, except a source of extra thread or string within the reach of the weaver seated at the loom.

ldkocher

Hi,  I thought it was used to repair warp ends, but where would you clamp it?  It does clamp very firmly to the beam but you can't do it while warp is on and you can't have it at the base of the loom.  Did they have another extra board on the back of the loom or use another beam like what we now use for a second tension?

sequel (not verified)

Some looms have crosspieces near the floor, parallel to and below the back beam.  These are not the looms that have folding back beams.  I saw an article in a very old Shuttle Spindle and Dyepot that suggested these sort of "outrigger" spools for floating selvedges.  What I don't see on yours is any sort of tensioner for the thread that might be on it.  Of course it may just be a device to keep the cord of your iron from rubbing the edge of the ironing board! ;-)

ldkocher

Hi,  the spool does not spin easily because of the wing nut on one end and the spring on the other.  It carries about the same tension you would have when weaving fabric.  It was purchased from a weaving supply place that is no longer in existence.   Thanks for the thoughts.

 

Submitted by ldkocher on