I have refinished my Gimakra Standard. She is beautiful. Cleared a place in the family room and have it set up. In the process of tying up. Was putting my Texsolv heddles on the harness frame. Accidenly put one on as follows. Put the top loop on top harness then twisted the bottom loop the opposite. When I looked, it made the eye face front to back and not to the sides. Has any one installed their Texsolv heddles like this, and is there a problem doing it this way. Put some tention on the top and bottom harness frames and checked to see if the heddles still slide OK. No problem. I just haven't seen it, or read it any where to do it this way. It looks like it would be easier to thead. Is this ok to do, or is this a no no?

Comments

kerstinfroberg

As I am always moving heddles around in un-specific amounts, I have both directions mixed all the time. I haven't even noticed there is a difference in how to handle them when threading - so, IMO, just let them stay as they are.

But don't forget to secure them from falling off... *that* can really cause extra work! The holes in the heddle bars are for putting "security strings" from end to end.

And, while talking about mistakes... make sure that the top loop of the heddle is on the same shaft as is the bottom loop. (Don't ask me how I know...)

laurafry

If you have the heddles all facing the same way you can snug them closer together for high epi.  Otherwise I don't bother too much about them if they are twisted.  :)

Cheers,

Laura

Holmersu

Thank you for clearing this up! I have been agonizing about untwisting heddles. Now I can get on to warping!

Dawn McCarthy

If all are the same you could use a twist tie to secure the batch at the bottom of the heddle and just drag the batch off the bottom bar, turn and put it back on the other way.

Dawn

 

Submitted by Anonymous (not verified) on