Please correct me if I'm wrong. I assume that as long as warp tension is equal across the entire warp, then it doesn't matter if you happen to tie-on or lash to your apron rods a little crooked, or if the rods get a little bowed in the tie-on/lash on process. I'm assuming this because as long as after the tie-on process your tension is even and tight that the warp will be pulled through the loom at an equal rate. 

I ask this as I see on this board discussions of tying on vs. lashing. While it appears that lashing may be easier to adjust the warp, the discussions make no mention of whether lashing doesn't bend or bow apron rods less than directly tying on.

Comments

kerstinfroberg

I almost don't dare to write this: in my experience, you are right. (At least up to a point.) (Another heresy: my old loom isn't square, and that works, too. Have never woven more than 20 meters, but all that looked straight...)

One way to minimize bowing is to not have the whole apron rod in the ties (or apron) - let the piece outside your web be "free". And, if/when you replace the rod, remember that a square or rectangular cross section is stiffer than a round one. And that a hollow rod is stiffer than a solid, regardless of the cross section.

Weavin Steven

When you write that the part outside the web "be free" do you mean that for example if I have a weaving two feet wide, that only two feet of the rod should be tied to the apron? That would seem to make sense to me.

laurafry

Like Kerstin, I've not had difficulty with a slightly bent or crooked apron rod so long as the warp tied to it is consistently tensioned.  

cheers,
Laura 

kerstinfroberg

Yes, that's what I mean.

My looms ('xcept the AVL) don't have cloth aprons, they have (usually) 5 cords (max width 120 cm - I suppose wider looms have more cords). It is of course impossible to have less than 3 cords attached, with this configuration.

Submitted by Weavin Steven on