I have an AVL Home loom that I bought second-hand.  It's in really good condition, but I noticed that the eyes of the heddles are about 1.25" below the shuttle race, when the shafts are at rest (not lifted).  This causes  the threads to be pulled down at a sharp angle between the beater and the shafts.  The threads are all touching the inside top of the heddle eyes when under tension.  The beater is at its lowest adjustment.

Is this normal?  Should I try to change something to either lift the shafts or lower the beater, or is this OK?  It seems to me that this puts a lot of unnecessary stress on the threads. 

This is my second loom, and quite frankly, I can't remember if my first loom had this same configuration.

Comments

Michael White

As a rule of thumb. On a jack loom the eye is set below the shuttle race. How much depends on what type of yarn you are using and your loom. 1.25 inch sames a lot. There is a AVL group you can sign up for (for free) or just wait, you will have a lot of replies here.

On a counter balance/counter march loom the warp yarn goes though the middle of the reed.

Michael

Joanne Hall

Hi Fifth,

I was teaching at the John Campbell Folk School last week and I noticed that on the AVL home loom that the beater was holding the warp threads up very high.  So, I guess that is normal for that loom.  All jack looms are made this way, as the shafts need to sit lower in the loom.  This is so the warp threads will rest on the shuttle race.  Only jack looms have shuttle races and they are there because the bottom of the shed cannot be tightened as tightly as on a cb or cm loom.  Since it is not as tight, it might not support the shuttle very well.  So, the shuttle race does that job.

Yes, it can cause wear.  I did not look at the loom to see if the shafts could be put a little higher.  Some looms do give you a beater adjustment so that you can lower the beater.  But if you are weaving with a very fragile warp thread, you might be able to put a dowel under the warp threads right behind the beater and use the dowel to hold the warp threads up just a little above the bottom of the reed.  You would need to have a way to hang this dowel from the top of the loom.  

Joanne

lkautio (not verified)

On a jack loom having the threads dip rather than come straight through puts more tension on them.  That way the tension on the bottom and top threads is more close to equal.  Not all jack looms require a shuttle race.  If the dip is sufficient or the sett is close enough it will generally support a shuttle without a race if you like that option.

Laurie Autio

fifthoffive (not verified)

Thanks, everyone.  I feel a lot smarter now.

Submitted by Anonymous (not verified) on