I have a raddle that I bought used many years ago. Because I warp front to back with a sectional beam, I have not used it. I want to warp chenille back to front and need it but it is an odd piece of equipment. It is 41 1/2" long but the part where the metal rods sit is 36" wide. It looks like it has a 5 1/2" handle on one end. The long side opposite the raddle rods is tappered. It appears that it fits into the beater slot but is too wide for my 36" loom. The beater slot is 42"  long so it will fit but cannot be centered so the full 36" cannot be warped.

The only way I think I can use it is to cut it down so it can be centered in the beater slot or clamping it to the back without cutting it.  Does anyone know the original use for this raddle?

Has anyone warped back to front with the raddle in the beater slot. How does that work?

Carolyn

 

Comments

ispintoweave

The picture was cropped when it uploaded. It does not show the 5 1/2" "handle" where there are no rods attached.

MJWallace

What type of loom do you have?  The instruction I am giving work well for Leclerc looms.

At the guild studio, we have Leclerc looms and center the raddle with the loom letting the 'handle' hang out the end of the beater slot.  The beater slot on the Leclerc looms are open ended. 

To use the raddle, the first thing I do is stablize the beater in a vertical position by taking a long cord or hockey lace, tie it around the castle sides, then go around the beater vertical sides then tie it around the front beam vertical supports.   If you tie up both side, the beater should be very stable.   

Place the raddle in the beater slot centred for the loom and secure the raddle to the beater.  The handle helps to keep the raddle vertical.  To keep the raddle in place, I use 3"-4" elastics but heavy string will work as well.  At each end, slip the elastic over one of raddle 'nails', take it down under the beater bottom, up the other side and over the nail again.  

Does this make sense?

EvaHall

If you can fit the raddle into the beater it will most likely work well. In Scandinavia we often use the reed, placed in the beater in stead of a raddle, when beaming back to front. When I use a raddle, I tie it to the back part of the loom.

ispintoweave

Thank you for both of your replies. It is good to know how a raddle with a handle is supposed to be used. Now it makes sense that it has a handle.

I have a copy of a Norwood loom. The beater slot is not open at the ends. The only way to use it in the beater is to cut off the handle if I want to center it in the beater. Thank you for your idea on how to keep the beater vertical. I like the suggestion of tying at the back of the loom. 

Submitted by ispintoweave on