I recently acquired a beautiful Orco 74 and while I encountered no issues dissembling and reassembling the loom, I did neglect to pay much attention to the treadle tie-up. I have never had a 4-harness counterbalance, all my experience is with a 4 harness direct tie up LeClerc Mira which I have not woven on in years. My thought was to tie up harnesses 1 and 3 to treadle 1 and 2 and 4 to treadle 6 - is that right? My other confusion is that the treadles are now very high above the surface of the floor and there is no way I could treadle while sitting comfortably at the loom other than to twist my leg upward and catch the treadle with the side of my heel - this doesn't seem right. I do recall that the treadles seemed high when I originally looked at the assembled loom in the seller's home. Seller is very petite and I on the other hand am almost 6 feet tall so am wondering if this could be a custom fit or if the Orco 74's typically have treadles rising higher than normal.
The loom came with a brake system consisting of a shaft that slips into the sectional beam to block forward advance. There is a rather large gauge "wire" running from this block to the shaft which would allow the weaver to push the shaft back once tension was released, advance the warp, reset the shaft (brake) and then tension using the front beam. I did also receive a brake similar to the Union (I have a 2-harness Union also) with a bar running the length of the back beam and interrupting the advancement by placing pressure on the pegs of the sectional warp. Any comments by Orco 74 users as to which they prefer?
Thank you in advance for the help - when I began weaving eons ago it was just me and a book, now I have the whole world to ask! Lin K/northern Illinois
Comments