Hello - 

Please bare with me I am new to weaving and still getting to know all the terms and how to use them.  I am weaving a dish cloth with Nialin 2/22 .  the yarn is the same for both warp and weft.  I have threaded the reed at 24 epi.  I am weaving a twill pattern. The book I am using lists the twill at 10 picks or 25 ppi.  I am only getting about 18  ppi (per inch).  I am trying to understand why I have a different ppi then listed?  What are some possible reasons for this?  I enjoy the twill pattern but the end result of the fabric is nowhere near as dense as I had hoped.  If you were to hold this up to the light , sunlight would shine through instead of being opaque .  Will some of this change once the piece has been washed?  I still don't see it changing that much though.?  Any thoughts on how I could do something differently for the next time?  I should mention I didn't have the called for 12 dent reed so I threded a 10 dent 2,3,2.3 .  

 

 

 

 

 

 

 

 

Comments

Sara von Tresckow

You may have a different loom type than in your project directions. Rising shed looms are known to pack the weft more loosely than countermarche or counterbalance looms.

You may not be packing your weft enough. The project doesn't give the pounds of ooomph needed to get your 25 ppi. First, you'll definitely have some shrinkage. If you double beat your weft it should become much closer - that is beat once sharply on the open shed. Change sheds and beat again sharply on the open shed BEFORE entering the next weft.

When you have woven many projects, you will be much better able to judge how a project will develop.

Joanne Hall

Along with what Sara has explained, you need to use a temple.  You may be pulling the weft too much, causing draw-in.  With a temple and an average loom, you should be able to get more than 24 ends per inch.  Even with a temple, you also need to angle your weft. 

Joanne

luna4

I have tried your suggestion to double beat the weft.  It does help.  It is a little bit of a funny series of steps to do over and over.  I don't have a temple yet, so this project is being done without one.  That was a interesting bit of info to learn that different looms  perform differently and it can create varying results.  In my case I learned on a jack loom so honestly I thought of a jack loom when I decided to buy.  Your info makes me want to weave on a counter balance or countermarch loom to see what it would be like.   

Sara von Tresckow

You do the double beat on the countershed looms as well - perhaps with less oomph. It is NOT a funny sequence, it is a useful one necessary to weave firm cloth. Beating just once is for delicate fabrics. 

Submitted by luna4 on