Hello to all,

I hope everyone is having a wonderful day. I would be if I wasn't having a heck of a time using my Ashford Table Loom. It is an 8 harness loom that I have used many, many times without issues. The last two things I wove on it was a silk chenille scard and a scarf woven with handspun cashmere and qiviut. I used the treadle kit with both since they were 4 harness weaves. Now I am trying to weave with Schaefer Andrea Silk lace weight yarn. I had no problems with the warping process. However, I can not get all four harnesses to sit at an even height. I have tried adjusting them and it all looks good until I start to weave. Then the 2nd harness all of a sudden is sitting at least  a half of an inch below the others. I am so frustrated with it at this point that if it weren't for the expense of the silk, I'd burn the loom for firewood. The other problem that I am having is the tex-solv cable that connects the harness to the treadle on harness keeps getting stuck on the threads. I'm afraid I'll end up breaking a thread.

My second question is about how much tension do you put on the warp to weave? Should it be really tight, or should there be some looseness in the warp?

Thanks for all your help. Take care and have a great day!

 

Ellen

[email protected]

Comments

sequel (not verified)

The tension should be not tighter than necessary to get a good shed.  If it is too tight, the shafts will not return to a resting position.  If it is too loose, the sheds will not separate easily and you'll have lots of skips.

Tighten it so it's bouncy, not tight as a banjo string, and not loose and sloppy either.

Submitted by Anonymous (not verified) on