In the huge stash of rayon yarn that I purchased some time ago, I found a tightly chained warp of beautiful custom dyed 4/2 rayon. It consists of 150 ends and is about 3 1/2 yds long in the chain - because it is chained tightly, I am guessing that it is at least a 9 yd warp. I would love to use this for scarves (actually, I wish it were more than 150 ends because I really would like to make table runners with it), but there is no cross. Is there any way I can get this warp on the loom without a lot of aggravation? Gail

Comments

Dena (not verified)

I once lost my cross on a 30 yd, 400 thread chenille warp (and lived to tell the tale!).  The trick is taking a deep breath, not getting freaked out by the tangles and believing you can.  My guess is that at only 150 threads, 3 1/2 yds long and a relatively slippery yarn that you won't have too much trouble.

laurafry

Like Dena says, patience and calm.  150 ends isn't all that many.  Just take it slowly and deal with the tangles as they come - don't let them snag into 'knots'.

cheers,

Laura

r1mein54 (not verified)

You can do it.  Just do not hurry and do not pull ANY loops tight. I would anchor/tie off the knot end of the chain and work open and pulling loose the loop end if you can tell which is which.

theresasc

enough to play with the chain with no cross, you could always fold the chain in half and turn it into a 300 end warp at half the length.  That way you might have the width you would need for a runner.  I have done this with striped warps but they did have crosses.  It sure would make a great weaving story:)

Submitted by gailc on