I'm working on a Leclerc loom (believed to be a jack-type Colonial, most similar to this model http://www.leclerclooms.com/draw_inst/da_col_old.PDF , but I can't find a serial number, it's a friend's loom she found at a tag sale years ago) 

I'm having some trouble getting the tie up and treadling to function. I'm trying to set up treadles for two different 5 harness satins (1/4 and 3/2). The harnesses and treadles are set up with Texsolv cord and arrow pegs but I can't seem to get them to sit evenly or balance. 

The harnesses attach to the floating lam and jacks with texsolv cord, but I cannot figure out a way to balance the harnesses so that the warp lays flat in the reed while keeping the floating lam from resting in the lam support and depressing all the treadles. 

The harnesses appear to not have enough weight to counter the treadle tie up pulling the floating lam down. 

I've never worked with this kind of tie up before and I'm well out of my depth. Any assisstance or experience with this kind of loom would be greatly appreciated! 

Thanks so much for all your help! 

Comments

sequel (not verified)

I've only ever tied up the counterbalance version of this loom, but I'm pretty good at looms in general. 

First - make sure the side piece, 165-CL is attached correctly at the castle.  There are 2 settings, one for jack, one for counterbalance.  The one for counterbalance will have the warp going straight from back to front and in the center of the reed.  The other notch, I think, will set the back beam higher, so the warp dips below the breast beam and lies on the shuttle race.

Second - once the shafts are correctly positioned with the heddle eyes about 2" below the height of the breast beam, make sure you have used the correct eyelet on the lamms to connect to the heddle frames.  There are 2, for some reason, on the counterbalanced lamms.  We use the right hand one for those.

Third - Put a warp on.  On some looms, it helps.  Doesn't need to be something you will actually weave, but enough to stablize the shafts.  Like 1 end per inch - 36 inches wide.

Then tie up your treadles.

 

 

 

Joanne Hall

Leclerc makes treadle springs for their 8 shaft jack looms.  Contact them about it.

Joanne

Submitted by sbaskin on