I need some help bad! i have a new baby wolf loom and i have the pedals attached to the heddle bars for the pattern i am weaving, BUT my problem is that the other pedals are just lying on the floor! What do i do with them? do i attach them also to the cords with the brown "buttons", if so, then how hard is it to pick out which pedals i need to weave with??? i hope this isn't too complicated, but i don't want to move the loom with the pedals lying right on the floor! this is prolly stupid but it's my first experience with a floor loom like the wolf. thanks! Charline

Comments

mneligh

There is no reason not to leave them lying on the floor unless you are moving the loom (actually carrying it , not rolling it).  In fact, I find it easier to leave them down so I don't accidentally use them.  That said, newer baby wolfs have a dowel that attaches to its set of tie up cords via rubber bands.  If you tie them to those cords, they do nothing if you accidentally treadle them.  If you don't have that feature, you can still attach them to a single lamm (the bar that makes the jack scissor when you pull it down, making the shaft frame go up).  Put rubber bands around either all the active or all the inactive treadles at a point where you will not only see but feel them, and weave barefoot or in a light foot covering.  I actually mark different points in patterns with up to 3 sets of rubber bands on my Macomber, but there are more treadles on it.

endorph

the treadles I am not using lying on the floor with my Mighty Wolf - I have six treadles and if I only need four I leave two on the floor so I don't accidently step on them.
Submitted by Anonymous (not verified) on