Hi All,

I’m a college student fairly new to weaving and was wondering if anyone had some suggestions for a project I’m working on. My friend supplied me with some stranded plastic material that comes in a lot of colors, and I thought it would be cool to weave it into a belt. The plastic strands, which I’m using as the warp yarn, are fairly thick (about 0.17” in diameter). For the weft yarn, I’m using a flat fiber that’s about .15” thick. I’ve already tried once with a weaving pattern that looks like this:

 beltPattern

 

 

 

 

It’s tight enough, so the weft yarn seems to be ok in this diagonal pattern. The problem is that when I move around, the fiber chafes against my jeans and breaks; since the weave is knotted at either end, the whole thing fell apart. Is there any pattern I can weave in that would be stronger, or still hold up if one point breaks? I’ve heard a little bit about “double weaves”, but I’m not sure if that’s the best way to go about this. Any help would be appreciated, thanks!

 

Comments

laurafry

For increased durability, the textile must be denser.  If you are leaving that much space in the weft, try beating the yarns closer - less of an angle.   Is it the warp or the weft threads that are breaking?  Perhaps you are just using a fibre that isn't suitable for the purpose you are trying to accommodate....

cheers,

Laura

sally orgren

I am hoping ms.thimble weighs in here! She has shown me some inkle band weaving she tried using that colorful plastic stuff kids use for braiding bracelets and key fobs. (If she doesn't see this, search for her on Weavo and send her a PM.) I think her application was dog collars, so she was thinking durable and waterproof.

You might also want to pursue basket (or "off loom") weaving techniques for this particular material. 

MStromberg (not verified)

Laura - Thanks for the thoughts. It is the weft threads that are breaking; I'm going to try experimenting with a few different fibers. I guess the only requirement I have there is that it needs to be flat, as I want the finished belt to lie flat.

 

I think I was unclear about one of my objectives in the original post as well. Is there any sort of weave that is "redundant", that is to say, that if one of the weft yarns breaks, the weave is still guaranteed to hold?

 

Sally - The inkle band weaving looks interesting; thanks for pointing me towards that resource. I'm unfamiliar with this technique; do the strands normally stay together if the weft is broken?

I looked a little into basket weaving, but I wasn't sure that I could keep it as flat as I wanted. If the belt gets too thick I can't it through my belt loops. Again, very ignorant on this; is there any specific basket weave that comes to mind for this application?

laurafry

Sounds like you should look for a different weft, then.  As for a 'redundant' weave structure, I can't think of any off hand.  Weaving is done with  continuous thread in the warp and the weft - if either of those breaks, a hole will develop in the cloth.  About the only thing I can think of would be a knotting technique - macrame or something like that - but that might make the textile too thick for your purpose. 

cheers,

Laura

Bonnie Datta (not verified)

You could use a strand of some strong nylon fishing line along with your flat weft.  That would give your structure a kind of redundancy.  But if the flat weft is too weak it will likely give out eventually anyway.  Any time the warp and weft are too different there is always a likelihood that the stronger one will wear through the weaker one.

Using the same yarn for weft as you have for warp would produce a more durable belt, and if that is too thick then you might want to consider using a thinner warp.  Many thin threads are stronger than one thick one.

Bonnie.

 

Submitted by Anonymous (not verified) on