Can metal heddles and those made of texsol be combined? I have a pattern that calls for more metal heddles than I have. The loom I have came with texsol heddles, but I have replaced them with metal ones.

Comments

sally orgren

She said it didn't work well, and she would never do it again. I think she may have slipped all the texsolv heddles onto one side of her loom, and it was a jack loom. 

Maybe if you balanced the texsolv heddles on either side of each shaft, it might work better than her experience? 

laurafry

Or keep all of one type of heddles on the same shaft? Cheers Laura

conniela

Thank you so much for the feedback. I think I've decided to just order more of the metal heddles. I really like the way they work.

sally orgren

Conniela, I think taking the time to make them uniform is your best bet.

My guildmate tried her experiment on a table loom. So I think putting all metal or all texsolv on specific shafts may have worked.

But if this was attempted on a floor loom (jack), I am not sure it would work as well, as the weight of the shafts is related to the way the loom functions. If one shaft was suddenly lighter than the others due to texsolv heddles, you might have to put additional weights on the bottom of that shaft to equalize the shed?

(I posted a few more details just in case someone digs up this thread in the future with the same question.)

sarahnopp (not verified)

I would imagine that uniform heddles is the best. But if you make a threading error, wouldn't you tie a quick string heddle to make do in the midst of all the metal ones? Personally, I would probably not remember to count how many metal heddles I had, and would be forced to use whatever was to hand for whichever project was halfway on the loom LOL 

sally orgren

Another tip, I really *hate* moving heddles. So I keep a journal of my heddle count, sometimes just a piece of tape on the side of the loom's castle, so I don't ever have to recount heddles before moving them.

Another way to avoid moving heddles, I keep the preponderance of heddles on the first few shafts. Instead of moving heddles, sometimes I will split an especially dense threading on a particular shaft over two shafts instead. Then treadle them together, as if they were a single shaft.

Submitted by conniela on