I've been weaving for a little over a year, on a LeClerc Fanny, 4 shaft and no matter what I do -- such as beating the weft more tightly -- I can't get "up" to the correct ppi for various projects.  I'm weaving M&O towels right now, using 8/2 unmercerized cotton, with 2 threads per dent in a ten dent reed.  According to the pattern, I should have 24 ppi but I'm consistently getting 17 ppi.  Any suggestions?

Comments

Sara von Tresckow

1. Where does it say you need 24 ppi? You only have 20 epi.

2. If you are going for even numbers, 17 ppi after washing will be much closer to 20 epi.

3. Most fabric has a slight warp dominance. It gives the cloth grain and better handling than "balanced". Your 17ppi sounds quite correct.

Monica Bellas (not verified)

The pattern came from Handwoven magazine, and now that I look at it (again) it says 20 ppi under "Warp and Weft spacing."  (Sorry, my mistake!)  Based on your answer, am I right in assuming that the ppi refers to the weft *after* wet finishing?  If so, is there a general rule of thumb to follow regarding ppi on the loom and ppi after wet finishing?  Thanks Sara!

Sara von Tresckow

Basically, those magazine projects have to give some idea of what to aim for. Peprsonally Ii do not like true balanced weaves unless meant for stitching - that suggested ppi is after wet finishing - and your final assessment should be based on how you find the fabric. If it looks nice and feels like what you want, just use it with pride.

Joanne Hall

Try using a temple.  Not only will you easily get more ppi, but you won't have to beat hard to do it.  Weaving will be more pleasureable.

Joanne

Monica Bellas (not verified)

Thanks Joanne and Sara for your comments.  I've just bought a temple and will try using it on some of the towels on this warp!

Weavin Steven

An often overlooked reason as to why you may not be getting as high a ppi as you desire is that your selveges are drawing in. When this happens, you tend to get a "bowed" look to your weaving. It's not noticeable unless you look real close. Do this: bring the beater bar to the fell line of your weaving. Look at the selveges compared to the middle of the fell line. If your selveges are bunching then up the rest of the beater bar can't beat the rest of the pick. Your selveges are probably getting the correct ppi, but the rest of your project isn't. 

Monica Bellas (not verified)

Thanks, Segal.  I actually measured the ppi in the middle of the cloth but will compare it with the selvedge.

Submitted by Anonymous (not verified) on