Hello,

I purchased a worn 50-year-old 4-shaft counterbalance loom from my weaving studio. I'm a beginning weaver that has wove on other counterbalance looms at the community weaving studio but now that I am weaving at home on my own, I'm having problems with my loom.

Currently I am weaving a warp of rose path dish towels. This is my first project on this loom. As I started weaving the the third towel today, one of the tex solv cords snapped. (This is the longest main cord that connects the metal dowels holding the shafts to the main top wood dowel. The cord snapped very close to where the shafts connect to the cord. The other end of this same cord is very frayed and about to snap too. On the other side of the loom, the cord doesn't have any sign of wearing. See attached photo.) This is odd because they were just replaced with brand new tex solv cords when I started this warp. My weaving teacher came over to my home and showed me how to replace them, so I am assuming this isn't the problem. Why did they snap so quickly and only on one side?

Weaving through this warp has not been smooth. Alot of times when I'm weaving, the shafts become unbalanced after three to four picks.  I have to readjust the shafts to regain the shaft balance (by gently lifting the shafts so the cords redistribute themselves...) Something isn't right. The photo I've included is how the remaining cord is tied to the dowels.

I don't know much about counter balance looms and am frustrated that I can't weave on this long weekend!

Any suggestions or insight would be greatfully appreciated.

Andrea

 

Comments

sequel (not verified)

Were both sets of upper pulley cords exactly the same length?  Were all the lamm cords the same length (assuming a multiple tie-up loom)?

Your set-up looks okay, what did you use to determine the length of the cords?

Did you melt the ends of the Texsolv with a flame so they would not ravel???  The upper roller cords look a little frayed, and like a sweater sleeve, they will ravel away to nothing. 

 

Joanne Hall

on the end of each of the two middle metal rods, then the rods will not be turning on the cord.  Go to the Leclerc website and look at how they attach these middle dowels.  Each Leclerc dowel is a little shorter and has a pulley on the end.  This will prevent wear on the cords.

Also, does your loom have lamms?  Lamms will give you better sheds.

Another approach would be to replace the four shafts with a simple two dowel and heddle construction.  It is not necessary to have heavy shafts like these on a counterbalance loom.

If you go to our website homepage, glimakraUSA, and click on Learning about Looms, then click on basic loom information, you can read about counterbalance looms.  Maybe there is something we cannot see in the photo and these pages might help.

Joanne

 

celtinbirks

If you somehow secure the cord to the large wooden dowel (by staple or tack) things shouldn't slide around so much.

Good luck

WeaverBrandtner

Thank you all for your advice.

Sequel—All cords have been replaced and measured to the same length and ends have been burned.

Joanne—I ended up constructing a pulley system like you suggested and it works quite well. I also downloaded information on Counterbalance looms from your recommended website and already learned quite a bit more than when I started.

Celtinbirks—Added a tack which works well with the new pulley system.

Thanks again. Had a pleasant night weaving away...

 

 

 

 

Submitted by WeaverBrandtner on