The subject line says it all.  I got my new Inkle loom.  It came without instructions so I searched the internet to find out how to make heddles.  OK, heddles are tied.  Now I am ready to warp the loom.  How do I tie off the beginning and ends of the warp when I wrap the loom, say, three times with that color?

Any help or pointing me to a website is most welcome!

Comments

wilowind (not verified)

 

Simple, tie the beginning end To the ending end. IT makes a continuous warp, sort of.The first end & the last end will cross, but I usually put this cross in the back, underside of the loom & have not yet had a problem. Hope that helps.

Cathy S/Willowwind

 

Kristina (not verified)

 Hi Susan, I found a usefull link, that shows how to warp an inkle loom.

http://www.palmerlooms.com/palmerlooms7.html

Hope that helps!

Kristina

CraftinSusan

Thanks!  That is the exact information I needed.  I think that I was making it more complicated that it is.  I guess that because the bands are so narrow it is OK to tie the beginner and ends of the warp together without distorting the warp.  It took me some time to wrap my mind around that.

folledecouleur (not verified)

Hello, I joined this group exactly for this problem. If I understand well, I tie up an edddle warp beggining thread to an eddle one of the end and a non-eddle one at the beginning to a non-eddle of the end. Is that it ?

CraftinSusan

I am about done weaving my first band on my new Inkle loom.

I had a number of color changes and therefore a number of ends to tie off.  I grabbed several ends and had both the heddle and the non heddle warp ends.  I looked at the way the ends were lying and made sure that I tied them so I ended up with a continuous warp.  So how you tie the ends depends on your pattern.  That is more important than tying heddle to heddle or non-heddle to heddle.

folledecouleur (not verified)

I get it and finally have a visual way to figure it out. I gess I just don't have much experience in inkle looming, this is my second project. I had horrible errors in my warping in this one, and in the fist also, a bad warping stayed in til the end off weaving lol

folledecouleur (not verified)

Ho and by the way, thanks a lot for the link.

folledecouleur (not verified)

Here is my almost finished guitar strap, and with the rest of the warp I'll do my backstrap :

 

Here it's before beginning to weave,

and hier when I'm almost finished. Sorry for the bad positionning, I usualy work this way. As you see, I doubled the weft.

Submitted by Anonymous (not verified) on