I am using 8/2 cottom and thread the heddles 4,3,2,1 for plain weave, I had over 550 threads and was using a 12 dent reed on a 22" Harrisville loom which had about 475 openings, so I had to thread 3,2 across the reed to have enough opening in the reed for the amount of threads. So when I raise my 1,3 shafts I had sereral threads blocking the shed. So I worked to try to clear the shed, so I had an open shed. Then I opened my 2,4 shafts and had lot of threads blocking my shed. So I worked to try to fix the threads so I could have a clear shed for those shafts, but when I reopened shafts 1,3 I no longer had a clear shed, but more threads in the shed and so worked on those again to get a clear shed and reopened shafts 2,4 and it was no longer clear. I am lost as to what to do to have a clear shed to start weaving. Suggestion to try would be helpful.

Comments

Joanne Hall

Hi,

You may need to put a metal bar on top of each shaft to add more weight to it.  Then you can tighten your tension more. Since you have a jack loom, you need something that will hold your shafts down and more weight is probably needed.

Joanne

Weavalong (not verified)

I had the same problem last night after re-warping my loom (Ashford 4shaft). I found this morning that I hadn't placed my warp threads over the back rail on top of the roller.

 

I found that the threads that were not in play were saggy and loose and there wasn't decent shed. I re-did the back roller warp threads and the problem was solved.

 

I'm a total novice and this was the first warp done without supervision. Hope you solve your problem and sorry if I was no help at all.

titadeb (not verified)

Could you have crossed threads between the reed and the heddles?  In "Learning to Weave" she has pictures showing this and tells how to fix it.  It's from mixing up the order of a couple threads; you might have to cut them, rethread, then hang with weights off the back beam.  Or retie.

Submitted by Anonymous (not verified) on