Hi everyone -

I'm new to this group, but am a member of other groups here.  I have an Erica 20-inch rigid heddle loom, and have just purchased a Kromski 32-inch rigid heddle loom.  I also have backstrap looms, inkle looms, bead looms, etc.  My question is this- I have very carefully wound the warp on the back beam on two separate projects.  I've used paper on the back beam, and feel I am doing everything "right".  On the two projects I am specifically thinking of, one with Harrisville Shetland warp, and one with a Fisherman wool warp - when I am about 1/2 way through weaving the item, the end warps are pulling up tighter than the center warps.  With the Fisherman wool I was told it was the stretchiness of using the knitting-type yarn for the warp.  But the Harrisville Shetland is a warp yarn - does anyone have an idea of why this is happening?  I am progressing the item evenly as I work, but the end warps on both sides are pulling more tightly.

 

Thanks!

 

Laurie

Comments

Joanne Hall

Hi Laurie,

The problem is probably from two things.  First, you may have put a longer warp on.  And second, the paper is probably bending.  That allows the selvage threads to wind on a smaller circumference.  I suggest that if you put on a warp that is longer than an average length scarf, that you use very thin beaming sticks.  The beaming sticks are also helpful for covering the tie-on knots as them come around the cloth beam and cause bumps on the woven cloth.

Joanne

 

 

 

newenglandsimp… (not verified)

Hi Joanne - Thanks!  I'll try the beaming sticks.

 

Laurie

Karren K. Brito

How much narrower is the woven web than the warp is at the reed?

If you your web is narrower,  and it ususually is, this can make the edge warp travel at an angle and therefore a longer distance, making them tighter.  The solution here is to get your woven web wider, closer to the width of the warp.  Reducing the pull in will keep the tension on the edge warps or selveges more like the other warps.  To get the web wider you need to increase the angle you lay the weft or bubble it.  Look   at these instructions from Schacht Spindle :

 

Helpful Hints
1. To keep the edges of your weaving from pulling in, allow for extra weft by setting the weft in at an angle and not straight across. Pull the weft up to the edge of the warp, but do not pull it tight (Diagram 7).

I hope this helps.  If it is the warp winding, just remember it takes time to do it well.  I too use slats, not paper,when beaming.

newenglandsimp… (not verified)

Hi Karren - Thanks very much- no, the web isn't pulling in very much at all - it must be my beaming the warp.  Thanks for those instructions though, they are always a good reminder of using an angle.

 

Laurie

sarahnopp (not verified)

I just tied a stick across the back bar, in the cross, and am having good luck resolving the pulling in of the ends. I too had to use some paper on the back beam, as I ran out of the ground cloth stuff I normally use.

Submitted by Anonymous (not verified) on