Yet ANOTHER issue, 63 " Glimåkra, drall pulleys, clean shed, reasonable shed - that is until I treadle. With each treadle I cannot get the shafts to re-align. Treadles are set low enough so as not to split shed, elastics in place, moved the drall pulleys in to adjust for narrower width weave, the pattern harnesses and ground align nicely until I advance to next treadle, then in order to get the shed to re-align I have to straighten by hand which is time consuming. I moved the tie up to the center 6 treadles, tried tie up farthest away from pivot point etc.... The only thing different is I had to tie knots to secure the shaft cords as I am out of texsolv arrow pegs and not sure if there is some slipping causing the shafts to tilt a little.
It has been a long day and I cannot think clearly to figure out what the issue is? Suggestions very welcomed!
Dawn