Alison (not verified)

Thanks Judie - I would never have thought of that.

Claudia Segal (not verified)

You do lovely work! What loom ddo you have?

BTW, did you know you can include photos in your comment?  Check out the Help topics HERE.  The best browsers for seeing all the features on Weavo are Firefox and Chrome or Safari for Macs.

fdykes (not verified)

Thank You Claudia,My loom is a C.1900-1920 Harald Marquardsen countermarch 8 harness 8 treadle which I have just recently restored. It's photo is now in the Looms page. Frank.

TheLoominary (not verified)

Hi heyxu. Assuming your motor has a 1/4" shaft you will need a 1/4" shaft coupler. This can be purchased on-line at: http://www.surplussales.com. The bearing installed in my block is a 1/4" Router bearing, and can be purchased at most hardware stores. You may also need tapered drive centering points to hold your spools. Mine are of aluminum purchased on ebay, however they are no longer available. A 1/4" shaft tapered grinding stone (cone shaped stone), as used on a small die grinding tool, dipped in some liquid rubber as used for hand tool grips would make good center points.The dead end ( the wooden block with the bearing) and center point will need to slide in, or out to load your spool. The motor will need to be used with a speed controller (sewing machine foot switch). I purchased one on ebay. Hope this helps, Frank.

TheLoominary (not verified)

Hi heyxu. Assuming your motor has a 1/4" shaft you will need a 1/4" shaft coupler. This can be purchased on-line at: http://www.surplussales.com. The bearing installed in my block is a 1/4" Router bearing, and can be purchased at most hardware stores. You may also need tapered drive centering points to hold your spools. Mine are of aluminum purchased on ebay, however they are no longer available. A 1/4" shaft tapered grinding stone (cone shaped stone), as used on a small die grinding tool, dipped in some liquid rubber as used for hand tool grips would make good center points.The dead end ( the wooden block with the bearing) and center point will need to slide in, or out to load your spool. The motor will need to be used with a speed controller (sewing machine foot switch). I purchased one on ebay. Hope this helps, Frank.

TheLoominary (not verified)

Good luck with your latest project!,Frank

TheLoominary (not verified)

Happy to help, and keep building!

francorios (not verified)

Ahhh! You attached the warp by tying individual strings. I usually use one thread and wrap around the warp stick (beam). But for a loose weave like gauze, your way makes sense to keep the spacing far apart.

Please continue to post pictures of your process.
Have a good day!

graciela (not verified)

I bind ( attach) the warp because I want a perfect edge without fringe. (In the two edges).