Shafts lowering on their own - your help appreciated

Comments

Posted on Wed, 01/03/2018 - 17:33

I have an 8 shaft 10 treadle HD loom.  I tied up with only 3 shafts per treadle.  When I depress these treadles the other shafts magically float to the floor.  Is this a weight of the treadle issue?  I just can't figure out why this is happening.  Your help appreciated.

Posted on Wed, 01/03/2018 - 17:33

I have an 8 shaft 10 treadle HD loom.  I tied up with only 3 shafts per treadle.  When I depress these treadles the other shafts magically float to the floor.  Is this a weight of the treadle issue?  I just can't figure out why this is happening.  Your help appreciated.

Posted on Fri, 01/05/2018 - 02:01

Tell them what loom you have and they will help you.  I would need more information to answer your question.

Posted on Sun, 01/21/2018 - 19:59

I purchased this loom second hand last spring. The harness frames keep jumping off the cables. I looked up the instruction on the HD website, but they just don’t make any sense to me.  I have tried their steps to adjust the cables, but I still can’t get them to stay put.  Can you give me any advice?  I would appreciate any help or comments.