Ok, so I read Steve's wonderful description of how to direct warp the log cabin pattern and was thrilled he added it to the choices. Now, I discovered that I was doing it ALL wrong. Instead of separating my darks and lights from the pairs they were in when I wound the warp, I had threaded them in alternating pairs. Here's the picture, my explanation stinks.
And, I was weaving the same way and knew it looked wrong. So, I took the whole thing apart and rethreaded and tied on, spread the warp and began weaving again.
Now, I have this:
The contrast of the taupe and dark blue is not sufficient to show the log cabin pattern. Plus, although they are the same weight in yards per pound (ypp), the taupe yarn is round and chained and the blue is a thin worsted.
The photo is fuzzy but I think it you can see what I mean about the difference in the yarns.
Now, I need help figuring out what to do, I want to rewarp the entire project and somehow keep the navy warp and replace the taupe with a white wool yarn that is close in weight to the navy and will add more contrast. The only way I can figure out how to do this is to direct warp the white onto a large dowel which will act as a second back beam and I can hang it from the back of the loom. Sort of the warp weighted idea. Then, I would replace the taupe in the threading as I wind the warp, put it on this 2nd beam and beam it separately over the navy warp which is already tensioned nicely on the existing back beam.
Or, do I scrap the entire project, save the yarn (which was all free at a yarn swap) and start all over again.
I need some advice and ideas.
Claudia, totally bummed and a little embarrassed.
Comments